Veritas Storage Foundation™ for Oracle 5.0.1 Administrator's Guide

You can name a snapplan file whatever you choose. Each entry in the snapplan
file is a line in parameter=argument format.
Table 13-1 shows which parameters are set when using dbed_vmchecksnap to
create or validate a snapplan.
Table 13-1
Parameter values for dbed_vmchecksnap
ValueParameter
Specifies the snapshot version for this major
release of Veritas Storage Foundation for Oracle.
SNAPSHOT_VERSION
The name of the host where the primary database
resides.
PRIMARY_HOST
The name of the host where the database will be
imported.
SECONDARY_HOST
In case of single disk group: The name of the
VxVM disk group used by the primary database.
In case of multiple disk groups: Colon separated
list of names of the VxVM disk groups used by
the primary database.
PRIMARY_DG
The prefix to be attached to the primary disk
groups to create corresponding snapshot disk
groups.
Snapshot disk groups will take the name using
a combination of SNAPSHOT_DG_PREFIX and
the corresponding primary disk group name. It's
default value will be SNAP_
SNAPSHOT_DG_PREFIX
The name of the Oracle database. By default, the
name of the Oracle database is included in the
snapplan.
ORACLE_SID
The full path of the archive logs.
There are several archive log destinations that
can be used for database recovery if you are
muliplexing the archive logs. You must specify
which archive log destination to use.
It is recommended that you have the archive log
destination on a separate volume if
SNAPSHOT_ARCHIVE_LOG is yes.
ARCHIVELOG_DEST
Using Database FlashSnap for backup and off-host processing
Creating a snapplan (dbed_vmchecksnap)
254