Veritas Storage Foundation for Oracle 5.0 Graphical User Interface Guide, HP-UX 11i v3, First Edition, May 2008

If you create a clone database using an existing snapplan, you use a portion of the
Create Clone Database wizard depending on the status of the snapplan you select:
■ SNAPSHOT_END status: picks up at Create Snapshot point in the process. This
status uses the default snapplan settings.
■ INIT_FULL status: picks up at Validate/Modify Snapplan. This status enables
selection of forced snapshot creation, authentication settings, and primary
database settings.
■ INIT_DB status: picks up at Create Snapplan. This status enables the review
and selection of all settings.
Creating a new snapplan for a clone database
If you are creating a clone database from a new snapplan, you must create the
new snapplan.
To create a clone database with a new snapplan
1
Access the Create Clone Database wizard.
See “Accessing clone database tasks in the Java GUI” on page 27.
See “Accessing database tasks in the Web GUI” on page 35.
2
Choose Database FlashSnap.
3
In the DatabaseFlashSnapClone Database dialog, select NewSnapplan.Click
Next.
The Create Snapplan dialog is displayed.
4
Confirm the Oracle SID. This is a read-only field.
5
Enter the following values:
■ Full path of the snapplan file
■ Name of the secondary host
■ Snapshot plex tag
6
Click Next to continue. The Validate/Modify Snapplan screen displays with
default values set.
See “To validate or modify a snapplan using the Create Clone Database wizard”
on page 54.
7
After the Validate/Modify Snapplan dialog, use the following dialog
procedures to complete the clone database:
■ See “To create a snapshot using the Create Clone Database wizard”
on page 55.
53Using a clone database
Creating a clone database