Veritas Storage Foundation for Oracle 5.0 Graphical User Interface Guide, HP-UX 11i v3, First Edition, May 2008

Table A-1
(continued)
Allowed OperationsCompleted OperationsSnapshot status (as seen
in the Snapplan State
field)
■ Recover the snapshot
database manually, then
run the
db2ed_vmclonedb -o
update_status
command from the CLI
Note: This option is not
supported in the GUI.
■ Create Snapshot Database
with the Restart
database option (failed)
recoverdb_start
■ Shut Down Database with
the umount option
■ Create Snapshot Database
with the Restart
database option
(successful)
recoverdb_end
■ Unmount Snapshot
Database with the
umount option
■ Create Snapshot Database
with the Restart
database option
(successful)
recoverdb_end
■ Verify that your file
system(s) are not busy
and retry the command.
■ dbed_vmclonedb -o
umount command failed
from the CLI
umount_start
■ Verify that your file
system(s) are not busy
and retry the command.
■ db2ed_vmclonedb -o
umount command failed
from the CLI
Note: This option is not
supported in the GUI.
umount_start
■ Start Up Snapshot
Database with the restart
database option
■ Resync Snapshot
■ Reverse Resync Snapshot
with the begin option
■ dbed_vmclonedb -o
umount command from
the CLI was successful
Note: This option is not
supported in the GUI.
umount_end
121Veritas Database FlashSnap status information
Obtaining database FlashSnap snapshot status and database status from the GUI