Veritas Storage Foundation for Oracle 5.0 Administrator's Guide, HP-UX 11i v3, Second Edition, December 2008

To delete a clone database and the Storage Checkpoint used to create it
◆
Use the dbed_clonedbcommand as follows:
$ /opt/VRTS/bin/dbed_clonedb -S NEW9 -o umount -d
Creating and working with snapplans using dbed_vmchecksnap
A snapplan specifies snapshot scenarios for a database (such as online, instant,
or offline). You can name a snapplan file whatever you choose.
The dbed_vmchecksnap command is supported by Veritas Storage Foundation for
Oracle RAC.
You can use the dbed_vmchecksnap -o setdefaults option to create the snapplan
and set default values for the parameters. You may then modify the snapplan file
using a text editor.
You can also use the command to validate, copy, list, or remove a snapplan and
check the storage to make sure it is configured appropriately for the Database
FlashSnap feature.
See “Validating a snapplan (dbed_vmchecksnap)” on page 255.
Note: You must have the Enterprise Edition of Veritas Storage Foundation for
Oracle to use this command.
Snapplan parameters
When using dbed_vmchecksnap -o setdefaults option to create the snapplan,
the following parameters are set:
Table A-4
Snapplan parameters
ValueParameter
Specifies the snapshot version for this release of Veritas
Storage Foundation for Oracle
SNAPSHOT_VERSION
Specifies the name of the host where the primary database
resides.
In Oracle RAC, PRIMARY_HOST specifies the host name of
the CVM master node.
PRIMARY_HOST
Veritas Storage Foundation for Oracle Command Line Interface
About the command line interface
336