Veritas Storage Foundation Cross-Platform Data Sharing 5.0 AdministratorÆs Guide, HP-UX 11i v3, First Edition, May 2008

58 Error codes and error recovery
333 Non-CDS disk cannot be placed in a
CDS disk group
Do one of the following:
■ Add the disk to another disk
group that is a non-CDS disk
group.
■ Re-initialize the disk as a CDS
disk so that it can be added to the
CDS disk group.
■ Change the CDS disk group into a
non-CDS disk group and then
add the disk.
334 Disk group alignment not CDS
compatible
Change the alignment of the disk
group to 8K and then retry setting the
CDS attribute for the disk group.
335 Subdisk length violates disk group
alignment
Ensure that sub-disk length value is a
multiple of 8K.
336 Subdisk offset violates disk group
alignment
Ensure that sub-disk offset value is a
multiple of 8K.
337 Subdisk plex offset violates disk
group alignment
Ensure that sub-disk plex offset value
is a multiple of 8K.
338 Plex stripe width violates disk group
alignment
Ensure that plex stripe width value is
a multiple of 8K.
339 Volume or log length violates disk
group alignment
Ensure that thelength of the volume
is a multiple of 8K.
For a log, set the value of the
dgalign_checking attribute to
round. This ensurs e that the length
of the log is silently rounded to a valid
value.
340 Last disk media offset violates disk
group alignment
Reassociate the DM record prior to
upgrading.
341 Too many device nodes in disk group Increase the number of device nodes
allowed in the disk group, if not
already at the maximum. Otherwise,
you need to remove volumes from the
disk group, possibly by splitting the
disk group.
Table B-1 Error codes and required actions
Error
number
Message Action