Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Table 5-1
Installation overview (continued)
SectionInstallation task
See “Downloading the Veritas Storage
Foundation Cluster File System software”
on page 31.
See “Mounting the product disc” on page 59.
Download the software, or insert the product
DVD.
See “Setting environment variables”
on page 32.
Set environment variables.
See “Creating the /opt directory” on page 33.Create the /opt directory, if it does not exist.
See “About configuring secure shell or
remote shell communication modes before
installing products” on page 405.
Configure the secure shell (ssh) on all nodes.
See “Supported HP-UX operating systems”
on page 48.
See “Release notes” on page 43.
Verify that hardware, software, and
operating system requirements are met.
See “Disk space requirements” on page 49.Check that sufficient disk space is available.
See “About the Veritas installer” on page 60.Use the installer to install the products.
About installing Veritas Storage Foundation Cluster
File System on HP-UX
For an initial installation on a new system, you can use one of the installation
procedures described in this section. If you have an existing installation of Storage
Foundation Cluster File System that you are upgrading, you must perform an
upgrade to move to the 5.1 SP1 versions of the Veritas products.
Summary of Veritas Storage Foundation installation
tasks
Installation of Veritas Storage Foundation products consists of the following
tasks:
■ Obtain a license key, if required.
■ If the operating system is not at the required OS fusion level, upgrade the
operating system to the latest release.
Installing Storage Foundation Cluster File System using the common product installer
About installing Veritas Storage Foundation Cluster File System on HP-UX
58