Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Table C-1
Response file variables specific to configuring disk-based I/O fencing
(continued)
DescriptionList or ScalarVariable
Specifies the I/O fencing mechanism.
This variable is not required if you had
configured fencing in disabled mode.
For disk-based fencing, you must
configure the vxfen_config
_fencing_mechanism variable and
either the vxfen_config_fencing_dg
variable or the vxfen_config
_fencing_newdg_disks variable.
(Optional)
ScalarCFG {vxfen_config
_fencing_mechanism}
Specifies the disk group for I/O fencing.
(Optional)
Note: You must define the
vxfen_config_fencing_dg variable to
use an existing disk group. If you want
to create a new disk group, you must
use both the vxfen_config_fencing_dg
variable and the
vxfen_config_fencing_newdg_disks
variable.
ScalarCFG{vxfen_config_fencing_dg}
Specifies the disks to use to create a
new disk group for I/O fencing.
(Optional)
Note: You must define the
vxfen_config_fencing_dg variable to
use an existing disk group. If you want
to create a new disk group, you must
use both the vxfen_config_fencing_dg
variable and the
vxfen_config_fencing_newdg_disks
variable.
ListCFG{vxfen_config
_fencing_newdg_disks}
Sample response file for configuring disk-based I/O
fencing
Review the disk-based I/O fencing response file variables and their definitions.
397Configuring I/O fencing using a response file
Sample response file for configuring disk-based I/O fencing