Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Table B-5 lists the response file variables that specify the required information
to configure LLT over UDP.
Table B-5
Response file variables specific to configuring LLT over UDP
DescriptionList or
Scalar
Variable
Indicates whether to configure heartbeat link
using LLT over UDP.
(Required)
ScalarCFG{lltoverudp}=1
Stores the IP address (IPv4 or IPv6) that the
heartbeat link uses on node1.
You can have four heartbeat links and <n>
for this response file variable can take values
1 to 4 for the respective heartbeat links.
(Required)
ScalarCFG{vcs_udplink<n>_address}
{<system1>}
Stores the IP address (IPv4 or IPv6) that the
low-priority heartbeat link uses on node1.
You can have four low-priority heartbeat links
and <n> for this response file variable can
take values 1 to 4 for the respective
low-priority heartbeat links.
(Required)
ScalarCFG
{vcs_udplinklowpri<n>_address}
{<system1>}
Stores the UDP port (16-bit integer value) that
the heartbeat link uses on node1.
You can have four heartbeat links and <n>
for this response file variable can take values
1 to 4 for the respective heartbeat links.
(Required)
ScalarCFG{vcs_udplink<n>_port}
{<system1>}
Stores the UDP port (16-bit integer value) that
the low-priority heartbeat link uses on node1.
You can have four low-priority heartbeat links
and <n> for this response file variable can
take values 1 to 4 for the respective
low-priority heartbeat links.
(Required)
ScalarCFG{vcs_udplinklowpri<n>_port}
{<system1>}
387Response files
Response file variables to configure Storage Foundation Cluster File System