Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Table B-3
Response file variables specific to configuring a basic Storage
Foundation Cluster File System cluster (continued)
DescriptionList or ScalarVariable
In a Storage Foundation Cluster
File System configuration, defines
if fencing is enabled.
Valid values are 0 or 1.
(Required)
Scalar$CFG{fencingenabled}
Table B-4 lists the response file variables that specify the required information
to configure LLT over Ethernet.
Table B-4
Response file variables specific to configuring private LLT over
Ethernet
DescriptionList or ScalarVariable
Defines the NIC to be used for a
private heartbeat link on each
system. Two LLT links are required
per system (lltlink1 and lltlink2).
You can configure up to four LLT
links.
You must enclose the system name
within double quotes.
(Required)
ScalarCFG{vcs_lltlink#}
{"system"}
Defines a low-priority heartbeat
link. Typically, lltlinklowpri is used
on a public network link to provide
an additional layer of
communication.
If you use different media speed for
the private NICs, you can configure
the NICs with lesser speed as
low-priority links to enhance LLT
performance. For example,
lltlinklowpri1, lltlinklowpri2, and
so on.
You must enclose the system name
within double quotes.
(Optional)
ScalarCFG{vcs_lltlinklowpri#}
{"system"}
Response files
Response file variables to configure Storage Foundation Cluster File System
386