Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

To use the installation script, enter the script name at the prompt. For example,
to install Veritas Storage Foundation, type ./installsf at the prompt.
Installation script options
Table A-1 shows command line options for the installation script. For an initial
install or upgrade, options are not usually required. The installation script options
apply to all Veritas Storage Foundation product scripts, except where otherwise
noted.
See “About installation scripts” on page 369.
Table A-1
Available command line options
FunctionCommand Line Option
Specifies the systems on which to run the
installation options. A system name is required
for all options. If not specified, the command
prompts for a system name.
system1 system2...
Adds a node to a high availability cluster.–addnode
Displays all depots and patches required for the
specified product. The depots and patches are
listed in correct installation order. The output
can be used to create scripts for command line
installs, or for installations over a network.
–allpkgs
The -comcleanup option removes the ssh or
remsh configuration added by installer on the
systems. The option is only required when
installation routines that performed
auto-configuration of ssh or remsh are abruptly
terminated.
–comcleanup
Configures the product after installation.–configure
Installation scripts
Installation script options
370