Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Path (dec) Initiator ID SCSI Rate Auto Term
-------------- ------------ --------- ---------
0/3/0/0 7 Fast Unknown
The output in this example shows the SCSI ID is 7, the preset default for the
HBA as shipped.
■ If you choose, you can leave the ID set at 7 and return to the Main Menu:
Service Menu: enter command or menu > main
■ You can change the SCSI ID for the HBA. For example, to change the SCSI
ID from 7 to 6, you would enter:
Service Menu: Enter command > SCSI init 0/3/0/0 6
FAST
■ To verity the change, enter "SCSI" at the prompt:
Service Menu: Enter command > SCSI
Path (dec) Initiator ID SCSI Rate Auto
Term
-------------- ------------ --------- ---------
0/3/0/0 6 Fast Unknown
7
Return to the Main Menu:
Service Menu: enter command or menu > main
8
At the Main Menu, enter the command to boot the system. Answer "n" when
you are prompted to interact with IPL:
Menu: Enter command or menu > boot
Interact with IPL (Y, N, or Cancel)?> n
Booting...
Setting up shared storage: Fibre Channel
Perform the following steps to set up Fibre Channel.
37Before you install
Setting up shared storage