Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

# vradmin -g oradatadg -c rac1_ckpt syncrvg rac1_rvg
clus2
2
To start replication after full synchronization, enter the following command:
# vradmin -g oradatadg -c rac1_ckpt startrep rac1_rvg
clus2
Verifying replication status
Verify that replication is properly functioning.
To verify replication status
1
Check the status of VVR replication:
# vradmin -g disk_group_name repstatus rvg_name
2
Review the flags output for the status. The output may appear as connected
and consistent. For example:
# vxprint -g oradatadg -l rlk_clus2_1_rac1_rvg
Rlink: rlk_clus2_1_rac1_rvg
info: timeout=500 packet_size=8400 rid=0.1078
latency_high_mark=10000 latency_low_mark=9950
bandwidth_limit=none
state: state=ACTIVE
synchronous=off latencyprot=off srlprot=autodcm
.
.
protocol: UDP/IP
checkpoint: rac1_ckpt
flags: write enabled attached consistent connected
asynchronous
Configuring VCS to replicate the database volume
using VVR
After configuring both clusters for global clustering and setting up the application
database for replication, configure VCS to provide high availability for the
database. Specifically, configure VCS agents to control the cluster resources,
including the replication resources.
333Configuring a global cluster using VVR
Configuring VCS to replicate the database volume using VVR