Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

HostName: 10.190.99.197
RvgName: rac1_rvg
DgName: oradatadg
datavol_cnt: 1
vset_cnt: 0
srl: rac1_srl
RLinks:
name=rlk_clus1_1_rac1_rvg, detached=on,
synchronous=off
Note: Once the replication is started the value of the detached flag will change
the status from OFF to ON.
Starting replication of application database volume
When you have both the primary and secondary sites set up for replication, you
can start replication from the primary site to the secondary site.
Start with the default replication settings:
■ Mode of replication: synchronous=off
■ Latency Protection: latencyprot=off
■ SRL overflow protection: srlprot_autodcm
■ Packet size: packet_size=8400
■ Network protocol: protocol=UDP
Method of initial synchronization:
■ Automatic synchronization
■ Full synchronization with Checkpoint
For guidelines on modifying these settings and information on choosing the
method of replication for the initial synchronization:
See the Veritas Volume Replicator Administrator’s Guide
Starting replication using automatic synchronization
Use the vradmin command to start replication or the transfer of data from the
primary site to the secondary site over the network. Because the cluster on the
secondary site uses only one host name, the command does not require the sec_host
argument.
331Configuring a global cluster using VVR
Starting replication of application database volume