Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Create the Unique Universal Identifier file /etc/vx/.uuids/clusuuid on the

new node:

# uuidconfig.pl -remsh -clus -copy \

-from_sys galaxy -to_sys saturn

Start the LLT, GAB, and ODM drivers on the new node:

# /sbin/init.d/llt start

# sbin/init.d/gab start

# /sbin/init.d/vxfen start

# kcmodule vxgms=loaded

# kcmodule odm=loaded

# /sbin/init.d/odm stop

# /sbin/init.d/odm start

On the new node, verify that the GAB port memberships are a and d:

# gabconfig -a

GAB Port Memberships

===============================================================

Port a gen df204 membership 012

Port d gen df207 membership 012

Setting up the node to run in secure mode

You must follow this procedure only if you are adding a node to a cluster that is

running in secure mode. If you are adding a node to a cluster that is not running

in a secure mode, proceed with configuring LLT and GAB.

Table 18-1 uses the following information for the following command examples.

Table 18-1

The command examples definitions

FunctionFully-qualified host name

(FQHN)

Name

The new node that you are

adding to the cluster.

saturn.nodes.example.comsaturn

Adding a node to a cluster

288