Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Verifying that the products were installed
Verify that the SFCFS products are installed.
You can use the swlist command to check which depots have been installed:
# swlist -l product | grep VRTS
Use the following sections to further verify the product installation.
Installation log files
After every product installation, the installer creates three text files:
■ Installation log file
■ Response file
■ Summary file
The name and location of each file is displayed at the end of a product installation,
and are always located in the /opt/VRTS/install/logs directory. It is
recommended that you keep the files for auditing, debugging, and future use.
Using the installation log file
The installation log file contains all commands executed during the procedure,
their output, and errors generated by the commands. This file is for debugging
installation problems and can be used for analysis by Veritas Support.
Using the summary file
The summary file contains the results of the installation by the installer or product
installation scripts. The summary includes the list of the packages, and the status
(success or failure) of each package. The summary also indicates which processes
were stopped or restarted during the installation. After installation, refer to the
summary file to determine whether any processes need to be started.
About enabling LDAP authentication for clusters that
run in secure mode
Symantec Product Authentication Service (AT) supports LDAP (Lightweight
Directory Access Protocol) user authentication through a plug-in for the
Verifying the Storage Foundation Cluster File System installation
Verifying that the products were installed
250