Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

You are prompted to enter the system names on which the software is to be

installed. Enter the system name or names and then press Return.

Depending on your existing configuration, various messages and prompts

may appear. Answer the prompts appropriately.

You are prompted to agree with the End User License Agreement. Enter y

and press Return.

Do you agree with the terms of the End User License Agreement as specified

in the storage_foundation/EULA/en/EULA_SF_Ux_5.1SP1.pdf file present on

media? [y,n,q,?] y

The installer lists the packages that will be installed or updated. You are

prompted to confirm that you are ready to stop SF processes.

Do you want to stop SF processes now? [y,n,q,?] (y) y

If you select y, the installer stops the product processes and makes some

configuration updates before upgrading.

The installer uninstalls and reinstalls the listed packages.

Uncomment the entries in /etc/fstab which were commented as part of

the pre-upgrade steps.

Enable I/O fencing if required. Perform the following steps to enable fencing.

■ Change the /etc/vxfenmode file to enable fencing.

# cp /etc/vxfen.d/vxfenmode_scsi3_dmp /etc/vxfenmode

■ Set the clusterwide attribute "UseFence" to use SCSI3. Add the following

line to the /etc/VRTSvcs/conf/config/main.cf file:

UseFence=SCSI3

■ Verify the syntax of the /etc/VRTSvcs/conf/config/main.cf file by running

the following commands:

# cd /etc/VRTSvcs/conf/config

# /opt/VRTS/bin/hacf -verify .

Reboot all the nodes.

# /usr/sbin/shutdown -r now

Performing a phased upgrade

Upgrading Storage Foundation Cluster File System and High Availability software from a release prior to 5.1 SP1

234