Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Start Storage Foundation High Availability 5.1 SP1 for HP-UX 11i v3 using

the following command:

# ./ installsfha -start

Check if the VEA service was restarted:

# /opt/VRTS/bin/vxsvcctrl status

If the VEA service is not running, restart it:

# /opt/VRTS/bin/vxsvcctrl start

Disk groups that were created using VxVM 5.0 can be imported after upgrading

to VxVM 5.1.100. However, we recommend upgrading the VxVM disk groups

to the latest version.

Upgrading from SFHA or SFORAHA 4.1, 4.1 MP1, 4.1 MP2, 5.0.

5.0 MP1, or 5.0 MP2 on HP-UX 11i v2 to SFHA 5.1 SP1 on HP-UX

11i v3

If your systems are already running Storage Foundation High Availability 4.1, 4.1

MP1, 4.1 MP2, 5.0. 5.0 MP1, or 5.0 MP2 on HP-UX 11i v2, you must upgrade the

operating system to HP-UX 11i v3. Then upgrade Storage Foundation High

Availability to Storage Foundation High Availability 5.1 SP1.

■ Prepare to upgrade Veritas products

See “Preparing to upgrade the Veritas software” on page 194.

■ Prepare to upgrade SFHA or SFORAHA on HP-UX 11iv2 to HP-UX 11iv3

See “Preparing to upgrade SFHA or SFORAHA on HP-UX 11i v2 to HP-UX 11i

v3” on page 231.

■ Upgrade HP-UX

See “Upgrading the HP-UX operating system” on page 237.

■ Upgrade SFHA

See “Upgrading SFHA or SFORA HA on HP-UX 11i v2 to 5.1 SP1” on page 233.

Preparing to upgrade SFHA or SFORAHA on HP-UX 11i v2 to HP-UX 11i v3

Perform the following steps before you upgrade SFHA or SFORAHA on HP-UX

11i v2 to SFHA on HP-UX 11i v3.

231Performing a phased upgrade

Upgrading Storage Foundation Cluster File System and High Availability software from a release prior to 5.1 SP1