Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

22
Set the clusterwide attribute "UseFence" to use SCSI3. Add the following line
to the /etc/VRTSvcs/conf/config/main.cf file:
UseFence=SCSI3
23
Start the VCS engine on each system:
# hastart
Performing a full upgrade from SFCFS 5.x on HP-UX
11iv3 to 5.1 SP1 HP-UX 11iv3
Use this full upgrade procedure if the operating system upgrade is not required.
To perform a full upgrade from SFCFS 5.x on HP-UX 11iv3 to 5.1 SP1 HP-UX 11iv3
1
Take offline all VCS groups that contain CFSMount and CVMVolDg
# hagrp -offline group -sys system01
# hagrp -offline group -sys system02
2
Unmount all the non-system VxFS file systems which are not under VCS
control.
# umount /mount_point
Note: Here the CVM is up.
3
Upgrade the stack following the installation of all the required patches.
4
Reboot the cluster.
# /usr/sbin/shutdown -r -y now
Performing a full upgrade from SFCFS 5.x on HP-UX
11iv3 to 5.1 SP1 on the latest HP-UX 11iv3
Use this full upgrade procedure if the operating system upgrade is required.
Performing a typical SFCFS upgrade using the installer
Performing a full upgrade from SFCFS 5.x on HP-UX 11iv3 to 5.1 SP1 HP-UX 11iv3
208