Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

11
If the cluster-wide attribute “UseFence” is set to SCSI3, then reset the value
to NONE in the /etc/VRTSvcs/conf/config/main.cf file.
12
On each node, edit the /etc/vxfenmode file to configure I/O fencing in disabled
mode.
# cat /etc/vxfenmode
vxfen_mode=disabled
13
On each node, change LLT_START=0 in the file /etc/rc.config.d/lltconf.
14
On each node, remove the following device files:
# rm -f /dev/llt
# rm -f /dev/gab*
# rm -f /dev/vxfen
15
Upgrade the operating system from HP-UX 11iv2 to HP-UX 11iv3.
To upgrade from Veritas 5.0 releases on 11i v2, select the Base-VxFS-50,
Base-VxVM-50 and Base-VxTools-50 bundles while using update-ux (1M) .
16
If any patches to the HP-UX 11i v3 are required, install all the prerequisite
patches on all nodes before upgrading the Veritas products.
17
Install SFCFS 5.1 SP1.
# ./installer
From the installation menu, choose the G option for install and enter the
number for VERITAS Storage Foundation Cluster File System.
18
Uncomment the VxFS mount point entries in the /etc/fstab file.
19
Reboot all the nodes.
# /usr/sbin/shutdown -r now
20
Check for hastatus –summ.
21
Post Upgrade Tasks: Enable fencing.
# hastop -all
# cp /etc/vxfen.d/vxfenmode_scsi3_dmp /etc/vxfenmode
# /sbin/init.d/vxfen stop
# /sbin/init.d/vxfen start
207Performing a typical SFCFS upgrade using the installer
Performing a full upgrade from SFCFS versions on HP-UX 11i v2 to SFCFS 5.1 SP1