Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

(Optional) If a file system is not clean, enter the following commands for that

file system:

# fsck -F vxfs filesystem

# mount -F vxfs filesystem mountpoint

# umount mountpoint

This should complete any extended operations that were outstanding on the

file system and unmount the file system cleanly.

There may be a pending large fileset clone removal extended operation if the

umount command fails with the following error:

file system device busy

An extended operation is pending if the following message is generated on

the console:

Storage Checkpoint asynchronous operation on file_system

file system still in progress.

(Optional) If an extended operation is pending, you must leave the file system

mounted for a longer time to allow the operation to complete. Removing a

very large fileset clone can take several hours.

(Optional) Repeat step 9 to verify that the unclean file system is now clean.

Stop all the volumes by entering the following command for each disk group:

# vxvol -g diskgroup stopall

To verify that no volumes remain open, use the following command:

# vxprint -Aht -e v_open

Comment out the non-system local VxFS mount points from the /etc/fstab.

Make a record of the mount points for VxFS file systems and VxVM volumes

that are defined in the /etc/fstab file. You will need to uncomment these

entries in the /etc/fstab file on the upgraded system.

If Veritas Volume Replicator (VVR) is configured, do the following steps in

the order shown:

■ Verify that all of the Primary RLINKs are up to date:

# vxrlink -g diskgroup status rlink_name

■ Detach the RLINKs.

Preparing to upgrade Veritas Storage Foundation Cluster File System

Preparing to upgrade

196