Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Enter the total number of coordination points as 1.

Enter the total number of co-ordination points including both

CP servers and disks: [b] (3) 1

Read the installer warning carefully before you proceed with the configuration.

Provide the following CP server details at the installer prompt:

■ Enter the virtual IP address or the host name of the virtual IP address for

the CP server. The installer assumes these values to be identical as viewed

from all the application cluster nodes.

Enter the Virtual IP address/fully qualified host name

for the Co-ordination Point Server #1:

[b] 10.209.80.197

■ Enter the port that the CP server would be listening on.

Enter the port in the range [49152, 65535] which the

Co-ordination Point Server 10.209.80.197

would be listening on or simply accept the default port suggested:

[b] (14250)

Verify and confirm the coordination points information for the fencing

configuration.

For example:

Total number of coordination points being used: 1

CP Server (Port):

1. 10.209.80.197 (14250)

If the CP server is configured for security, the installer sets up secure

communication between the CP server and the Storage Foundation Cluster

File System (application cluster):

■ Make sure that the security configuration in the application cluster and

the CP server is the same. If CP server is configured for security, ensure

that the application cluster also runs in secure mode.

■ If the CP server is configured for security, perform the following steps:

■ Review the output as the installer verifies if the Storage Foundation

Cluster File System (application cluster) nodes have already established

trust with an AT root broker.

Configuring SFCFS for data integrity

Setting up server-based I/O fencing using installsfcfs

166