Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Configuring Veritas Storage Foundation Cluster File
System manually
You can manually configure different products within Veritas Storage Foundation
Cluster File System.
Configuring Veritas Volume Manager
Use the following procedures to configure Veritas Volume Manager. If you have
installed and configured VxVM using the product installer, you do not need to
complete the procedures in this section.
For information on setting up VxVM disk groups and volumes after installation,
see "Configuring Veritas Volume Manager" in the Veritas Volume Manager
Administrator’s Guide.
Configuring Veritas Volume Manager with the installvm script
If you deferred configuring VxVM during installation, you can configure it by
running the installvm script with the -configure option.
To configure VxVM using the installvm script
1
Enter the following commands.
# cd /dvdrom/volume_manager
# ./installvm -configure
2
The script runs an initial system check, and will tell you that you cannot
configure already configured features such as enclosure-based naming and
default disk groups.
3
Decide whether you want to set up the enclosure-based naming scheme:
Do you want to set up the enclosure-based naming scheme? [y, n, q]
4
You are then asked if you want to set up a default disk group for each system:
Do you want to set up a default disk group for each system? [y, n, q]
5
If you have a VVR license installed, the next phase concerns configuration
of VVR:
Do you want to change any of the VVR ports ... [y, n, q]
137Configuring Veritas Storage Foundation Cluster File System
Configuring Veritas Storage Foundation Cluster File System manually