Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Select the Configure SMTP check box.
If each system uses a separate NIC, select the Configure NICs
for every system separately check box.
If all the systems use the same NIC, select the NIC for the VCS
Notifier to be used on all systems. If not, select the NIC to be
used by each system.
In the SMTP Server box, enter the domain-based hostname
of the SMTP server. Example: smtp.yourcompany.com
In the Recipient box, enter the full email address of the SMTP
recipient. Example: user@yourcompany.com.
In the Event list box, select the minimum security level of
messages to be sent to each recipient.
Click Add to add more SMTP recipients, if necessary.
SMTP
Select the Configure SNMP check box.
If each system uses a separate NIC, select the Configure NICs
for every system separately check box.
If all the systems use the same NIC, select the NIC for the VCS
Notifier to be used on all systems. If not, select the NIC to be
used by each system.
In the SNMP Port box, enter the SNMP trap daemon port:
(162).
In the Console System Name box, enter the SNMP console
system name.
In the Event list box, select the minimum security level of
messages to be sent to each console.
Click Add to add more SNMP consoles, if necessary.
SNMP
If you installed a valid HA/DR license, you can now enter the
wide-area heartbeat link details for the global cluster that you
would set up later.
See the Veritas Storage Foundation Cluster File System Installation
Guide for instructions to set up SFCFS global clusters.
Select the Configure GCO check box.
If each system uses a separate NIC, select the Configure NICs
for every system separately check box.
Select a NIC.
Enter a virtual IP address and value for the netmask.
Enter the value for the networkhosts.
You can use an IPv4 or an IPv6 address.
GCO
Click Next.
135Configuring Veritas Storage Foundation Cluster File System
Configuring Storage Foundation Cluster File System using the Web-based installer