Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

5
On the Set Cluster Name/ID page, specify the following information for the
cluster.
Enter a unique cluster name.Cluster Name
Enter a unique cluster ID.Cluster ID
Select an LLT type from the list. You can choose to configure
LLT over UDP or over Ethernet.
If you choose Auto detect over Ethernet, the installer
auto-detects the LLT links over Ethernet. Verify the links
and click Yes in the Confirmation dialog box. Skip to step
7. If you click No, you must manually enter the details to
configure LLT over Ethernet.
LLT Type
Choose the number of heartbeat links you want to configure.Number of Heartbeats
Select the check box if you want to configure a low priority
link. The installer configures one heartbeat link as low
priority link.
LowPriority Heartbeat
NIC
For LLT over Ethernet, select the check box if you do not
want to use the same NIC details to configure private
heartbeat links on other systems.
For LLT over UDP, this check box is selected by default.
UniqueHeartbeat NICs
per system
Click Next.
6
On the Set Cluster Heartbeat page, select the heartbeat link details for the
LLT type you chose on the Set Cluster Name/ID page.
Do the following:
■ If you are using the same NICs on all the systems, select
the NIC for each private heartbeat link.
■ If you had selected Unique Heartbeat NICs per system
on the Set Cluster Name/ID page, provide the NIC details
for each system.
For LLT over Ethernet:
Select the NIC, Port, and IP address for each private
heartbeat link. You must provide these details for each
system.
For LLT over UDP:
Click Next.
133Configuring Veritas Storage Foundation Cluster File System
Configuring Storage Foundation Cluster File System using the Web-based installer