Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Replacing a Storage Foundation Cluster File System demo license with a
permanent license
When a Storage Foundation Cluster File System demo key license expires, you
can replace it with a permanent license using the vxlicinst(1) program.
To replace a demo key
1
Make sure you have permissions to log in as root on each of the nodes in the
cluster.
2
Shut down Storage Foundation Cluster File System on all nodes in the cluster:
# hastop -all -force
This command does not shut down any running applications.
3
Enter the permanent license key using the following command on each node:
# vxlicinst -k XXXX-XXXX-XXXX-XXXX-XXXX-XXX
4
Make sure demo licenses are replaced on all cluster nodes before starting
Storage Foundation Cluster File System.
# vxlicrep
5
Start Storage Foundation Cluster File System on each node:
# hastart
Configuring Storage Foundation Cluster File System
using the Web-based installer
Before you begin to configure Storage Foundation Cluster File System using the
Web-based installer, review the configuration requirements.
Note: If you want to reconfigure Storage Foundation Cluster File System, before
you start the installer you must stop all the resources that are under VCS control
using the hastop command or the hagrp -offline command.
By default, the communication between the systems is selected as SSH. If SSH is
used for communication between systems, the SSH commands execute without
prompting for passwords or confirmations.
131Configuring Veritas Storage Foundation Cluster File System
Configuring Storage Foundation Cluster File System using the Web-based installer