Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

■ Enter the virtual IP address.

Enter the Virtual IP address for the Cluster:

[b,q,?] 2001:454e:205a:110:203:baff:feee:10

■ Enter the prefix for the virtual IPv6 address you provided. For

example:

Enter the Prefix for IP

2001:454e:205a:110:203:baff:feee:10: [b,q,?] 64

■ Enter the NetworkHosts IP addresses that are separated with

spaces for checking the connections.

Enter the NetworkHosts IP addresses, separated

by spaces: [b,q,?] 2001:db8::1 2001:db8::2

■ Verify and confirm the Cluster Virtual IP information.

Cluster Virtual IP verification:

NIC: lan0

IP: 2001:454e:205a:110:203:baff:feee:10

Prefix: 64

NetworkHosts: 2001:db8::1 2001:db8::2

Is this information correct? [y,n,q] (y)

For IPv6

Configuring the cluster in secure mode

If you want to configure the cluster in secure mode, make sure that you meet the

prerequisites for secure cluster configuration.

The installer provides different configuration modes to configure a secure cluster.

Make sure that you completed the pre-configuration tasks for the configuration

mode that you want to choose.

See “Preparing to configure the clusters in secure mode” on page 73.

To configure the cluster in secure mode

Choose whether to configure Storage Foundation Cluster File System to use

Symantec Product Authentication Service.

Would you like to configure VCS to use Symantec Security

Services? [y,n,q] (n) y

119Configuring Veritas Storage Foundation Cluster File System

Configuring Veritas Storage Foundation Cluster File System using the script-based installer