Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

■ Option 2: LLT over UDP (answer installer questions)
Make sure that each NIC you want to use as heartbeat link has an IP
address configured. Enter the heartbeat link details at the installer prompt
to configure LLT over UDP. If you had not already configured IP addresses
to the NICs, the installer provides you an option to detect the IP address
for a given NIC.
Skip to step 3.
■ Option 3: LLT over Ethernet (allow installer to detect)
Allow the installer to automatically detect the heartbeat link details to
configure LLT over Ethernet. The installer tries to detect all connected
links between all systems.
Skip to step 5.
2
If you chose option 1, enter the network interface card details for the private
heartbeat links.
The installer discovers and lists the network interface cards. You can use
either the standard interfaces or the aggregated interfaces (bonded NICs).
You must not enter the network interface card that is used for the public
network (typically lan0.)
Enter the NIC for the first private heartbeat link on galaxy:
[b,q,?] lan0
lan0 has an IP address configured on it. It could be a
public NIC on galaxy.
Are you sure you want to use lan0 for the first private
heartbeat link? [y,n,q,b,?] (n) y
Would you like to configure a second private heartbeat link?
[y,n,q,b,?] (y)
Enter the NIC for the second private heartbeat link on galaxy:
[b,q,?] lan1
lan1 has an IP address configured on it. It could be a
public NIC on galaxy.
Are you sure you want to use lan1 for the second private
heartbeat link? [y,n,q,b,?] (n) y
Would you like to configure a third private heartbeat link?
[y,n,q,b,?](n)
Do you want to configure an additional low priority heartbeat
link? [y,n,q,b,?] (n)
115Configuring Veritas Storage Foundation Cluster File System
Configuring Veritas Storage Foundation Cluster File System using the script-based installer