Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

The CP server requires SFHA to be installed and configured before its
configuration.
■ Checks to see if the CP server is already configured on the system.
If the CP server is already configured, then the configuration utility
informs the user and requests that the user unconfigure the CP server
before trying to configure it.
5
Enter the name of the CP server.
Enter the name of the CP Server: mycps1.symantecexample.com
6
Enter a valid virtual IP address on which the CP server process should depend
on.
Enter a valid Virtual IP address on which
the CP Server process should depend on:
10.209.83.85
You can also use IPv6 address.
7
Enter the CP server port number or press Enter to accept the default value
(14250).
Enter a port number in range [49152, 65535], or
press <enter> for default port (14250):
8
Choose whether the communication between the CP server and the SFCFS
clusters has to be made secure.
If you have not configured the CP server cluster in secure mode, enter n at
the prompt.
Warning: If the CP server cluster is not configured in secure mode, and if you
enter y, then the script immediately exits. You must configure the CP server
cluster in secure mode and rerun the CP server configuration script.
Veritas recommends secure communication between the CP server and
application clusters. Enabling security requires Symantec Product
Authentication Service to be installed and configured on the cluster.
Do you want to enable Security for the communications? (y/n)
(Default:y) :
105Preparing to configure SFCFS
Setting up the CP server