Veritas™ File System 5.0.1 Administrator's Guide

file system does not support extent attributes, has a different block size than the
source file system, or lacks free extents appropriate to satisfy the extent attribute
requirements.
The -e option takes any of the following keywords as an argument:
Issues a warning message if extent attribute information cannot be
maintained (the default)
warn
Fails the copy if extent attribute information cannot be maintainedforce
Ignores extent attribute information entirelyignore
Failure to preserve extent attributes
Whenever a file is copied, moved, or archived using commands that preserve
extent attributes, there is nevertheless the possibility of losing the attributes.
Such a failure might occur for one of the following reasons:
■ The file system receiving a copied, moved, or restored file from an archive is
not a VxFS type. Since other file system types do not support the extent
attributes of the VxFS file system, the attributes of the source file are lost
during the migration.
■ The file system receiving a copied, moved, or restored file is a VxFS type but
does not have enough free space to satisfy the extent attributes. For example,
consider a 50K file and a reservation of 1 MB. If the target file system has 500K
free, it could easily hold the file but fail to satisfy the reservation.
■ The file system receiving a copied, moved, or restored file from an archive is
a VxFS type but the different block sizes of the source and target file system
make extent attributes impossible to maintain. For example, consider a source
file system of block size 1024, a target file system of block size 4096, and a file
that has a fixed extent size of 3 blocks (3072 bytes). This fixed extent size
adapts to the source file system but cannot translate onto the target file system.
The same source and target file systems in the preceding example with a file
carrying a fixed extent size of 4 could preserve the attribute; a 4 block (4096
byte) extent on the source file system would translate into a 1 block extent on
the target.
On a system with mixed block sizes, a copy, move, or restoration operation
may or may not succeed in preserving attributes. It is recommended that the
same block size be used for all file systems on a given system.
67Extent attributes
Commands related to extent attributes