VERITAS File System 3.5 (HP OnlineJFS/JFS 3.5) Release Notes

VERITAS File System 3.5 (HP OnlineJFS/JFS 3.5) Release Notes
Compatibility Information and Installation Requirements
Chapter 1
20
Compatibility Information and Installation
Requirements
Supported
Operating System
The HP-UX 11i 64-bit versions are the only operating systems supported by VERITAS
File System 3.5 (HP OnlineJFS/JFS 3.5) product. The September 2002 HP-UX 11i (or
later) release is the required operating system configuration.
Supported
Migration
Scenarios
The VERITAS File System 3.5 (HP OnlineJFS/JFS 3.5) is the first release in HP-UX 11i.
As such, there is no operating system upgrade path from HP-UX 11.00 with HP
OnlineJFS/JFS 3.1/3.3 to VERITAS File System 3.5 (HP OnlineJFS/JFS 3.5) in HP-UX
11i.
Supported
Hardware
Architecture
Only the following hardware platforms are supported by HP OnlineJFS/JFS 3.5:
Recommended
Memory
Requirement
HP recommends a minimum of 512 megabytes of memory to use VERITAS File System
3.5 (HP OnlineJFS/JFS 3.5).
Disk Space
Requirements
Before installing the software, make sure that there is sufficient storage space on your
target system. The following table shows the minimum space required and the directory
distribution for each package. All values are shown in megabytes.
NOTE The space requirement for /stand is the estimated space needed to save a copy of the old
kernel for a typical system. You may require more or less space, depending on your
configuration.
Table 1-3 Supported Hardware Architecture
Superdome rp8400
rp24xx K-Class, 64-Bit
rp5400 R-class, 64-bit
rp7400 J6000, 64-bit
Directory JFS Package
VRTSvlic
Package
/stand 40 0
/usr 10 0
/var 10
/sbin 10 2
/etc 2.4 .05
/opt 04
Total 64 7