Veritas 5.0 Installation Guide (September 2006)

Removing VxFS 5.0 and VxVM 5.0
Chapter 646
* Target connection succeeded for "<server>:/".
* Software selections:
Base-VxVM-50,r=B.05.00,a=HP-UX_B.11.23_IA/PA,v=HP
.
.
* Execution succeeded.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log <server> @ <server>:/".
======= 08/10/06 13:21:57 MDT END swremove SESSION (non-interactive)
(jobid=<job_id>)
NOTE After removing the Veritas products, the system reboots.
Any errors that occur during the software removal process are due to the following:
• System contains open volumes.
• Root disk is under VxVM control.
Check the log file /var/adm/sw/swagent.log for more information.
Removing Base-VxFS-50
This section describes how to remove Base-VxFS-50.
The new tunables since VxFS 5.0, such as inode_aging_size, inode_aging_count,
fcl_maxalloc, fcl_keeptime, fcl_winterval, fcl_ointerval, and oltp_load, must be
removed from the tunefstab file. The earlier versions of VxFS do not recognise these
tunables.
NOTE VxFS 3.5 will be activated after the removal of Base-VxFS-50.
CAUTION Do not remove the VRTSvlic package if there are any other Veritas products
running on your system.