Veritas 5.0 Installation Guide (September 2006)

Installing VxFS 5.0 and VxVM 5.0
Chapter 430
* Beginning Selection
* Target connection succeeded for "<server>:/".
* Software selections:
Base-VxVM-50,r=B.05.00,a=HP-UX_B.11.23_IA/PA,v=HP
.
.
* Verification succeeded.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log <server>@:/".
======= 08/10/06 13:21:57 MDT END swverify SESSION (non-interactive)
(jobid=<job_id>)
NOTE You must install the patches PHCO_35129 and, PHKL_35130 after installing
Base-VxVM-50.
Installing the Full VxVM (B9116CA)
You can install Full VxVM either in the non-interactive mode, or in the interactive mode.
Installing Full VxVM in the Non-Interactive Mode
To install Full VxVM in the non-interactive mode, enter the following:
# swinstall -x autoreboot=true -s <depot_path> B9116CA
The following output is displayed:
======= 08/10/06 13:21:57 MDT BEGIN swinstall SESSION
(non-interactive) (jobid=<job_id>)
* Session started for user "root@<server>".
* Beginning Selection
* Target connection succeeded for "<server>:/".
* Source:<depot_location>
* Targets: <server>:/