Veritas 5.0 Installation Guide (September 2006)

Installing VxFS 5.0 and VxVM 5.0
Installing Base-VxVM-50
Chapter 4 27
* Software selections:
B3929FA,r=5.0.01.02,a=HP-UX_B.11.23_IA/PA,v=HP
.
.
* Verification succeeded.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log @ <server>:/".
======= 08/10/2006 13:21:57 MDT END swverify SESSION (non-interactive)
(jobid=<job_id>)
Installing Base-VxVM-50
You can install Base-VxVM-50 either in the non-interactive mode or in the interactive mode.
NOTE Ensure that you select the complete bundle Base-VxVM-50 for installation
while installing Full-VxVM bundle B9116CA if your system already does not
have Base-VxVM-50.
Also verify that the bundles Base-VxVM-50, Base-VxFS-50 and B9116CA are
present on your system after installing B9116CA.
Installing Base-VxVM-50 in the Non-Interactive Mode
To install Base-VxVM-50 in the non-interactive mode, enter the following command:
# swinstall -x autoreboot=true -s <depot-path> Base-VxVM-50
The following output is displayed:
======= 08/10/06 13:21:57 MDT BEGIN swinstall SESSION
(non-interactive) (jobid=<job_id>)
* Session started for user "root@<server>".
* Beginning Selection
* Target connection succeeded for "<server>:/".
* Source:<depot_location>
* Targets: <server>:/