Veritas 5.0 Installation Guide (September 2006)

Installing VxFS 5.0 and VxVM 5.0
Chapter 422
been installed. The AVXFS and AVXVM products (contained within VxFS 5.0
and VxVM 5.0, respectively) will check the installed products and cause an
installation failure for the 5.0 products on such systems.
Installing Base-VxFS-50
You can install Base-VxFS-50 either in the non-interactive mode or in the interactive mode.
Installing Base-VxFS-50 in the Non-Interactive Mode
To install Base-VxFS-50 non-interactively, run the following command:
# swinstall -x autoreboot=true -s <depot-path> Base-VxFS-50
The following output is displayed:
======= 08/10/06 13:21:57 MDT BEGIN swinstall SESSION
(non-interactive) (jobid=<job_id>)
* Session started for user "root@<server>".
* Beginning Selection
* Target connection succeeded for "<server>:/".
* Source:<depot_location>
* Targets: <server>:/
* Software selections:
Base-VxVM-50,r=B.05.00,a=HP-UX_B.11.23_IA/PA,v=HP
.
.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log <server>@ <server>:/".
======= 08/10/06 13:21:57 MDT END swinstall SESSION (non-interactive)
(jobid=<job_id>)
Installing Base-VxFS-50 in the Interactive Mode
To install Base-VxFS-50 in the interactive mode, complete the following steps: