Veritas 5.0 Installation Guide, HP-UX 11i v3, First Edition, May 2008

For more information on the supported options, see swinstall (1M).
Installing HP OnlineJFS (B3929FB) in the Interactive Mode
To install HP OnlineJFS (B3929FB) in the interactive mode, complete the following steps:
1. Enter the swinstall command in interactive mode, as follows:
# swinstall -s <depot-path>
2. Mark the B3929FB bundle on the SD Install Window.
3. Select Actions, and click Install. Follow the on-screen instructions to complete the installation.
Verifying HP OnlineJFS (B3929FB) Installation
Verify the installation of OnlineJFS (B3929FB) on your system by entering the following
command:
# swverify B3929FB
Fore more information on the supported options, see swverify (1M).
Installing VxVM 5.0
VxVM 5.0 consists of the Base-VxVM-50 and Full VxVM (B9116CB) bundles. The following
sections discuss the installation of these bundles using the HP-UX SD commands.
NOTE: After installing VxVM 5.0, if there were any prior VxVM version that had unbundled
Array Support Library (ASL) packages installed, the new unbundled ASL packages will not be
automatically installed with 5.0. You must download and install 5.0 unbundled ASLs separately
or swcopy VxVM 5.0 together with VxFS 5.0 and ASL packages into a single depot and install
the depot. The ASLs bundled together with base product will be updated automatically. For
more information on ASLs, see the Veritas Storage Foundation and High Availability Solutions 5.0
MP1 Hardware Compatibility List.
IMPORTANT: OnlineJFS 4.1 (B3929EA) must be removed before installing the Veritas 5.0
products.
Installing Base-VxVM-50
You can install Base-VxVM-50 either in the non-interactive mode, or in the interactive mode.
NOTE: Ensure that you select the complete Base-VxVM-50 bundle for installation while
installing Full-VxVM bundle B9116CB if your system already does not have Base-VxVM-50.
Also, verify that the bundles Base-VxVM-50, Base-VxFS-50, and B9116CB are present on your
system after installing B9116CB.
Installing Base-VxVM-50 in Non-Interactive Mode
Enter the swinstall command in non-interactive mode, as follows:
# swinstall -x autoreboot=true -s <depot-path> Base-VxVM-50
Fore more information on the supported options, see swinstall (1M).
The installation of VxVM also installs the VEA service and client packages. Installation of VxVM
5.0 pciks up VxFS 5.0 as a corequisite.
Installing Base-VxVM-50 in the Interactive Mode
To install Base-VxVM-50 in interactive mode, complete the following steps:
Installing VxVM 5.0 29