Migration from Legacy to Agile Naming Model in VxVM 5.0 on HP-UX 11i v3

The execution of the above command would result in VxVM 5.0 operating in
legacy mode.
# vxdmpadm getlungroup dmpnodename=c9t6d0
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME
==========================================================
c9t6d0 ENABLED Disk 1 1 0 Disk
# vxdmpadm getlungroup dmpnodename=disk9
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME
==========================================================
c9t6d0 ENABLED Disk 1 1 0 Disk
c. New/Agile Mode
In this mode of operation the output-naming model would always follow the
agile naming model.
vxddladm set namingscheme=osn mode=new
The execution of the above command would result in VxVM 5.0 operating in
agile addressing mode.
# vxdmpadm getlungroup dmpnodename=c9t6d0
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME
==========================================================
disk9 ENABLED Disk 1 1 0 Disk
# vxdmpadm getlungroup dmpnodename=disk9
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME
==========================================================
disk9 ENABLED Disk 1 1 0 Disk