Installation of VxFS and VxVM 4.1 on HP-UX 11i v3 September 2008 Operating Environment Update Release

ERROR: The system has VxVM configured, but the VERITAS Volume
Manager software was not selected for loading. You are required to
load it in order for the installation to succeed. Use the software
selection screen to mark the appropriate VxVM software for loading.
To update HP-UX 11i v2 systems and to remain at VxVM 4.1 in HP-
UX 11i v3, use the following command:
update-ux s <source_location> Base-VXVM
3. Cold-Installing HP-UX 11i v3
September 2008 with VxVM and
VxFS 4.1 from an Ignite-UX Server
This section describes the process to cold-install a system with HP-UX 11i v3,
Veritas VxVM 4.1, and VxFS 4.1 using an Ignite-UX server. It is assumed that some
depot server(s) should have been set up containing two depots, one with the HP-UX
11i v3 Operating Environment (OE) containing Veritas VxVM 5.0 and one with
the Veritas VxVM 4.1 software. Note that Veritas VxVM 5.0 and VxFS 5.0 are
included on the 11i v3 OE starting in September 2008, and VxVM 4.1 will need
to be copied from an older HP-UX 11i v3 OE.
Preparing the Ignite-UX Server
To prepare the Ignite-UX server, complete the following steps:
1. Enter the swinstall command to install Ignite-UX version C.7.7.47 (available
September, 2008) or later on an Ignite-UX server.
You can confirm the Ignite software version by entering the command swlist
Ignite-UX, or by viewing the contents of the /opt/ignite/Version file.
2. Create the configuration file for the HP-UX 11i v3 OE depot.
a. # cd /var/opt/ignite/data/Rel_B.11.31
b. For depots located on remote servers use:
# /opt/ignite/bin/make_config \
-s <depot_server>:<1131_OE_depot> \
-c <OE_config_filename>_cfg