HP JFS 3.3 and HP OnLineJFS 3.3 VERITAS File System 3.3 System Administrator's Guide

Appendix A 141
Kernel Messages
Kernel Messages
• Explanation
There were active files in the file system and they caused the
unmount to fail.
When the system is halted, the root file system is unmounted. This
happens occasionally when a process is hung and it can’t be killed
before unmounting the root.
• Action
fsck will run when the system is rebooted. It should clean up the file
system. No other action is necessary.
If the problem occurs every time the system is halted, determine the
cause and contact your customer support organization.
Message 024 WARNING: msgcnt x : vxfs: mesg 024: vx_cutwait -
mount_point file system current usage table update error
• Explanation
Update to the current usage table (CUT) failed.
For a Version 2 disk layout, the CUT contains a fileset version
number and total number of blocks used by each fileset.
The VX_FULLFSCK flag is set in the super-block. If the super-block
can’t be written, the file system is disabled.
• Action
Unmount the file system and use fsck to run a full structural check.
Message 025 WARNING: msgcnt x : vxfs: mesg 025: vx_wsuper -
mount_point file system
super_block update failed
• Explanation
An I/O error occurred while writing the super-block during a resize
operation. The file system is disabled.
• Action
Unmount the file system and use fsck to run a full structural check.
Check the console log for I/O errors. If the problem is a disk failure,
replace the disk before the file system is mounted for write access.
Message 026 WARNING: msgcnt x : vxfs: mesg 026: vx_snap_copyblk -
mount_point primary file system read error