HP JFS 3.3 and HP OnLineJFS 3.3 VERITAS File System 3.3 System Administrator's Guide

136 AppendixA
Kernel Messages
Kernel Messages
Table Size” in Chapter 5 , “Performance and Tuning”).
NOTE The tuneable parameter vx_ninode is used to set the value of
vxfs_ninode.
Message 015 WARNING: msgcnt x : vxfs: mesg 015: vx_ibadinactive -
mount_point file system can’t mark inode inumber bad
WARNING: msgcnt x : vxfs: mesg 015: vx_ilisterr -
mount_point file system can’t mark inode inumber bad
• Explanation
An attempt to mark an inode bad on disk, and the super-block update
to set the VX_FULLFSCK flag, failed. This indicates that a catastrophic
disk error may have occurred since both an inode list block and the
super-block had I/O failures. The file system is disabled to preserve
file system integrity.
• Action
Unmount the file system and use fsck to run a full structural check.
Check the console log for I/O errors. If the disk failed, replace it before
remounting the file system.
Message 016 WARNING: msgcnt x : vxfs: mesg 016: vx_ilisterr -
mount_point file system error reading inode inumber
• Explanation
An I/O error occurred while reading the inode list. The VX_FULLFSCK
flag is set.
• Action
Check the console log for I/O errors. If the problem was caused by a
disk failure, replace the disk before the file system is mounted for
write access. Unmount the file system and use fsck to run a full
structural check.
Message 017 WARNING: msgcnt x : vxfs: mesg 017: vx_attr_getblk -
mount_point file system inode inumber marked bad
WARNING: msgcnt x : vxfs: mesg 017: vx_attr_iget -
mount_point file system inode inumber marked bad
WARNING: msgcnt x : vxfs: mesg 017: vx_attr_indadd -
mount_point file system inode inumber marked bad