Cold Installation of VxFS 5.0.1 and VxVM 5.0.1 on HP-UX 11i v3 September 2009 Operating Environment Update Release

Base-VxTools-501 VERITAS Infrastructure Bundle 5.0.1 for HP-UX

Base-VxVM-501 Base VERITAS Volume Manager Bundle 5.0.1 for HP-UX

5. Use the Ignite-UX interface to deselect the VxVM 5.0 & VxFS 5.0 software if it is selected. On the Software

tab, deselect the following:

Base-VxFS-50(OE)

Base-VxTools-50(OE)

Base-VxVM-50(OE)

6. Make any other configuration choices required using the Ignite-UX interface, and select Go! to cold-install

the client.

Verifying the Client for the Required Software and Configuration

After the system boots, confirm that the client has the intended software and configuration.

To confirm the software and the configuration, complete the following steps:

1. Confirm the correct hostname.

Run the following command to display the hostname:

# hostname

2. Confirm the correct OE version.

Run the following command to display the OE version currently installed on the system:

# swlist | grep HPUX

3. Confirm the installation of the Base VERITAS Volume Manager Bundle 5.0.1 for HP-UX 11i v3.

Run the following command to display the VxVM 5.0.1 products installed on the system:

# swlist Base-VxVM-501

4. Confirm installation of the Veritas File System Bundle 5.0.1 for HP-UX 11i v3.

Run the following command to display the VxFS 5.0.1 products installed on the system:

# swlist Base-VxFS-501

contained herein is subject to change without notice. The only warranties for HP

products and services are set forth in the express warranty statements

accompanying such products and services. Nothing herein should be construed as

constituting an additional warranty. HP shall not be liable for technical or editorial

errors or omissions contained herein.

HP-UX Release 10.20 and later and HP-UX Release 11.00 and later (in both 32 and

64-bit configurations) on all HP 9000 computers are Open Group UNIX 95

branded products.

5900-0546, E1209