WU-FTPD 2.6.1 release notes (5900-1739, May 2011)

Table 5 Defects Fixed in the HP-UX 11i v1 Operating System (continued)
DescriptionIdentifier
In an FTP session, when the command ls is executed with the pathname of any
file followed by /., FTP displays the long listing of the file instead of displaying
the error message not found.
For instance, when the ls /etc/passwd/. command is issued in an FTP session,
the long listing of the file /etc/passwd is displayed.
JAGae21322
In WU-FTPD 2.6.1, user access cannot be limited through the /etc/ftpd/
ftpusers file.
JAGae12022/
QXCR1000512388
ftpd(1M) fails to do user authentication using identd(1M) in IPv6-enabled systems.JAGae62972/
QXCR1000521254
Defects fixed in WU-FTPD 2.6.1 (B.11.11.01.004)
ftpd(1M) does not work properly under certain situations.JAGaf20839/
QXCR1000535121
ftpd(1M) does not work correctly with certain group IDs.JAGaf11467/
QXCR1000532398
Defects fixed in WU-FTPD 2.6.1 (B.11.11.01.005)
In some situations, there is a delay in an FTP connection after the FTP client displays
the Connected to message.
JAGaf08674/
QXCR1000531669
Defects fixed in WU-FTPD 2.6.1 (B.11.11.01.006)
ftpd(1M) has a problem when a failure occurs in establishing a data connection
with the client.
JAGaf62718/
QXCR1000548386
ftpd(1) is unable to log into the virtual domain when the FTP server invoked by
inetd(1M) uses the ftpservers(4) configuration file to enable the virtual hosting
feature.
JAGaf54890/
QXCR1000545542
An anonymous user cannot log into a Trusted system.JAGaf40126/
QXCR1000540528
In an IPv6 environment, a delay may be observed in the FTP connection.JAGaf39590/
QXCR1000540388
No customer-visible symptoms in most cases.JAGaf39331/
QXCR1000540315
ftpd(1M) always uses the primary interface address of the system for the data
connection instead of using the address on which the control connection request
is received.
JAGaf35480/
QXCR1000539305
In an NFS-mounted file system, which is full, the ftp(1) get or mget command
fails without displaying any error message. Also, in some cases in a non-NFS
mounted system, which is full, ftp(1) get or mget command fails without displaying
any error message. As a result, unreported data loss may occur.
JAGaf33866/
QXCR1000538860
The restart command in ftp(1M) does not work properly when the restart marker
is set to a value greater than or equal to 2 GB.
JAGaf32059/
QXCR1000538330
Defects fixed in this release 35