Sendmail 8.13.3 release notes for HP-UX 11i v1, HP-UX 11i v2 and HP-UX 11i v3

value also limits the number of processes to deliver the envelopes; if more envelopes
are created they are only queued up and must be processed by a queue run.
• A new command-line option -T in identd(1M). This option specifies the maximum
number of seconds a server waits for the client's input before closing the connection
on timeout. By default, the timeout limit is 0 (zero); that is, the server waits for an
indefinite amount of time. This option is ignored for invalid timeout intervals.
NOTE: You need to install the patch PHNE_37726 to view this option. This patch
is available at the following location:
http://www.software.hp.com
Removed Features
Sendmail 8.13.3 does not include the following features:
• The DefaultAuthInfo option is replaced by a new ruleset authinfo. Use the
new option to return the client-side authentication information for AUTH.
• The UnsafeGroupWrites option of the sendmail.cf file is deprecated and is
replaced with the settings GroupWritableForwardFileSafe and
GroupWritableIncludeFileSafe in the DontBlameSendmail option.
Installing Sendmail 8.13.3
This section describes how to install Sendmail 8.13.3. It also lists the prerequisites for
installing Sendmail 8.13.3.
Prerequisites
To install Sendmail 8.13.3, you need an HP-UX 11i v1, HP-UX 11i v2, or HP-UX 11i v3
operating system. For the HP-UX 11i v2 operating system, ensure that the PHNE_31734
patch is installed in the system before installing the Sendmail 8.13.3 depot.
NOTE: You cannot install Sendmail 8.13.3 on a HP-UX 11i v1 system that already
contains the Web upgrade version of Sendmail 8.11.1. You must uninstall Sendmail
8.11.1 before installing Sendmail 8.13.3 on the system.
Installation Instructions
To install Sendmail 8.13.3, complete the following steps:
1. Review “Prerequisites” (page 9) to ensure your system meets Sendmail 8.13.3
installation requirements.
2. To download the Sendmail 8.13.3 software, complete the following steps:
Removed Features 9