Sendmail 8.13.3 release notes for HP-UX 11i v1, HP-UX 11i v2 and HP-UX 11i v3

NOTE: Previously, Identd and Sendmail were delivered under the same
product bundle name. You did not have the choice to install these products
separately.
Starting with the product bundles B.11.11.02.001 and B.11.23.1.001, Identd
and Sendmail are delivered as separate products in the Sendmail depot. The
Identd product delivered with Sendmail 8.13.3 is the same Identd binary
available in the Sendmail patch PHNE_29774 (for HP-UX 11i v1) and the
Identd binary available in the HP-UX 11i v2 September 2004 release.
3. To install both the products in the HP-UX 11i v1 or HP-UX v2 operating systems,
run the following command at the HP-UX prompt:
# swinstall -s /tmp/Sendmail-Upgrade.depot
To install only Sendmail 8.13.3, run the following command at the HP-UX prompt:
# swinstall -s /tmp/Sendmail-Upgrade.depot SMAIL-UPGRADE
where:
SMAIL-UPGRADE is the name of the Sendmail 8.13.3 Web upgrade product.
To install only the Identd product, run the following command at the HP-UX
prompt:
# swinstall -s /tmp/Sendmail-Upgrade.depot SMAIL-IDENT
where:
SMAIL-IDENT is the name of the Identd product.
To install the HPUX-MailServer product on a HP-UX 11i v3 operating system, run
the following command at the HP-UX prompt:
# swinstall -s <fully_qualified_depot_source_path>
NOTE: After installing Sendmail 8.13.3, HP recommends that you read the section
“Migrating from Sendmail 8.11.1 to Sendmail 8.13.3” (page 13) for issues related to
migration.
For more information on configuring and using Sendmail, see the HP-UX Mailing
Services Administrator’s Guide at
http://www.docs.hp.com/en/netcom.html#Internet%20Services
Installing Sendmail 8.13.3 11