OSI Troubleshooting Guide, May 1997

46 Chapter 1
Interoperability Testing
Reason and Refuse Codes
(0x08) N-Reject (NSAP unreachable/ Permanent)
Network connection could not be established
because the X.121 address was incorrect.
Use osiadmin or otsshowes
to examine the configured
X.121 address for this NSAP.
Verify if remote is up and
listening on the configured
address.
(0x09) N-Reset from NS Provider (No Reason)
Network connection was reset.
No recognized diagnostic is
provided.
(0x0a) N-Reset from NS Provider (Congestion)
Network connection was reset.
X.25 diagnostic indicates
provider was a problem.
(0x0b) N_Reject (Address Unknown)
No destination or route entry exists for the
given NSAP. Network connection cannot be
established.
Use osiadmin or otsaddes
to configure the destination
system.
(0x12) Disconnect for NS User Remote Transport
layer encountered a failure and abruptly
released the network connection.
(0x14) User N_Reject (Transient)
The remote Transport layer refused this
network connection request.
(0x15) User N_Reject (Permanent) The remote
Transport layer refused this network
connection request.
(0x16) User N_Reject (QOS unavail/ Transient)
QOS negotiation failure
(0x17) User N_Reject (QOS unavail/ Permanent)
QOS negotiation failure
(0x18) N_Reject ((Unrecognized NS-user- data)
Code Meaning Action