ONCplus B.11.31.18 Release Notes (762806-002, June 2014)

7. ONCplus B.11.31.02 may cause a boot panic situation if you are installing on an HP 9000
rp3410 or rp3440 system with the September 2007 release of HP-UX already installed. If
your system has this configuration, Hewlett-Packard recommends that you install the March
2008 release of HP-UX, which includes ONCplus B.11.31.02, or install ONCplus B.11.31.06.
You can use the "model" command to print the hardware model information. The output of
the "model" command on an HP 9000 rp3440 system is:
9000/800/rp3440
To determine if you have the September 2007 release of HP-UX installed, execute the command:
swlist -l bundle HPUX11i-*
The output includes either "B.11.31" or "B.11.31.yymm", where yymm identifies the year
and month of the HP-UX release that is installed. For example, if you have the HP-UX Mission
Critical Operating Environment and the September 2007 release of HP-UX installed, the output
would include:
HPUX11i-OE-MC B.11.31.0709 HP-UX
Mission Critical Operating Environment
NOTE: Starting with ONCplus B.11.31.12, the NFS client is enhanced to operate in the
SRP environment. So, when ONCplus B.11.31.12 is used in the SRP environment, it is
recommended not to revert to an earlier ONCplus version. Doing so may cause the NFS
functionality to behave unexpectedly in the SRP environment.
NOTE:
NOTE: ONCplus B.11.31.05 includes the fix for QXCR1000589225 which requires libc
patch PHCO_38048 to be installed in the following circumstances:
• the "retrans" option is set in the /etc/resolv.conf file
• there is a "dns" entry in the /etc/nsswitch.conf file (i.e. the ip6.arpa domain is
used to perform reverse IPv6 lookups) The libc patch is included with ONCplus beginning
with version B.11.31.06 and will not require a separate patch installation.
24 ONCplus B.11.31.18