ONCplus B.11.31.06 Release Notes

Table 1-1 ONCplus Software Fixes (continued)
ONCplus VersionDescriptionCR ID
B.11.31.01Users cannot access an NFS mounted file system in PAM enabled Kerberos
systems.
QXCR1000585959
B.11.31.01
The xdr_setpos function in libnsl.1 does not work properly.
QXCR1000586940
B.11.31.01Writing from an NFSv3 client to a Red Hat Linux server fails with an “RPC:
Server can't decode arguments” error message.
QXCR1000587604
B.11.31.01
The rpcbind daemon does not receive IPv6 multicast.
QXCR1000588479
For more information on these defects and how they were fixed, see:
http://www2.itrc.hp.com.
Installation Information
This section specifies the requirements for installing ONCplus B.11.31.06. It includes information
on installing ONCplus B.11.31.06 and verifying the ONCplus B.11.31.06 installation.
System Requirements
The following requirements are necessary for installing ONCplus B.11.31.06 :
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 65 MB
Installing ONCplus B.11.31.06
To install ONCplus B.11.31.06 on your system:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, issue the following
command:
swlist | grep ONCplus
The output should be similar to one of the following five lines:
ONCplus B.11.31.05 ONC+ 2.3
ONCplus B.11.31.04 ONC+ 2.3
ONCplus B.11.31.03 ONC+ 2.3
ONCplus B.11.31.02 ONC+ 2.3
ONCplus B.11.31.01 ONC+ 2.3
ONCplus B.11.31 ONC+ 2.3
3. After you download the ONCplus_B.11.31.06.depot file, move it to the /tmp directory:
/tmp/ONCplus_B.11.31.06.depot
4. Verify that the file has downloaded correctly using the swlist command as follows:
NOTE: You must specify the full path name of the source depot when you use swlist
and swinstall commands.
swlist -d @ /tmp/ONCplus_B.11.31.06.depot
If ONCplus is downloaded correctly, the output should include:
#
# Bundle(s):
10 ONCplus Release Notes