ONCplus B.11.31.05 Release Notes

System Requirements
The following requirements are necessary for installing ONCplus B.11.31.05 :
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 50 MB
Installing ONCplus B.11.31.05
To install ONCplus B.11.31.05 on your system:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, issue the following
command:
swlist | grep ONCplus
The output should be similar to one of the following five lines:
ONCplus B.11.31.04 ONC+ 2.3
ONCplus B.11.31.03 ONC+ 2.3
ONCplus B.11.31.02 ONC+ 2.3
ONCplus B.11.31.01 ONC+ 2.3
ONCplus B.11.31.LR ONC+ 2.3
3. After you download the ONCplus_B.11.31.05.depot file, move it to the /tmp directory:
/tmp/ONCplus_B.11.31.05.depot
4. Verify that the file has downloaded correctly using the swlist command as follows:
NOTE: You must specify the full path name of the source depot when you use swlist
and swinstall commands.
swlist -d @ /tmp/ONCplus_B.11.31.05.depot
If ONCplus downloads correctly, the following message appears:
ONCplus B.11.31.05 ONC+ 2.3
5. Back up your system before installing the product.
6. Enter the following command to install the product on a stand-alone system:
swinstall -x autoreboot=true -s \
/tmp/ONCplus_B.11.31.05.depot ONCplus
NOTE: ONCplus contains kernel filesets. Thus installing the product using the swinstall
command results in a system reboot after the installation is complete.
Verifying ONCplus B.11.31.05 Installation
To verify if the ONCplus B.11.31.05 installation is successful, follow these steps:
1. Issue the following command:
swverify ONCplus
If ONCplus B.11.31.05 is successfully installed, the following message is displayed:
Verification succeeded
10 ONCplus Release Notes