ONCplus B.11.31.04 Release Notes

6. Enter the following command to install the product on a stand-alone system:
swinstall -x autoreboot=true -s \
/tmp/ONCplus_B.11.31.04.depot ONCplus
NOTE: ONCplus contains kernel filesets. Thus swinstalling the product will result in a
system reboot after the installation is complete.
Verifying ONCplus B.11.31.04 Installation
To verify if the ONCplus B.11.31.04 installation is successful, follow these steps:
1. Issue the following command:
swverify ONCplus
If ONCplus B.11.31.04 is successfully installed, the following message displays:
Verification succeeded
2. To check which version of ONCplus is installed on your system, issue the following
command:
swlist | grep ONCplus
The output should be similar to the following:
ONCplus B.11.31.04 ONC+ 2.3
Reverting to a Previous Version of ONCplus
You cannot remove the current version of ONCplus with the swremove command. However,
you can revert to the previous version of ONCplus. The following section describes how to revert
to the previous version of ONCplus.
To revert to a previous version of ONCplus, follow these steps:
WARNING! ONCplus B.11.31.02 may cause a boot panic situation if you are installing on an
HP 9000 rp3410 or rp3440 system with the September 2007 release of HP-UX already installed.
If your system has this configuration, Hewlett-Packard recommends that you install the March
2008 release of HP-UX, which includes ONCplus B.11.31.02, or install ONCplus B.11.31.03 or
B.11.31.04. You can use the "model" command to print the hardware model information. The
output of the "model" command on an HP 9000 rp3440 system is:
9000/800/rp3440
To determine if you have the September 2007 release of HP-UX installed, issue the command:
swlist -l bundle HPUX11i-*
The output includes either "B.11.31" or "B.11.31.yymm", where yymm identifies the year and
month of the HP-UX release that is installed. For example, if you have the HP-UX Mission Critical
Operating Environment and the September 2007 release of HP-UX installed, the output would
include:
HPUX11i-OE-MC B.11.31.0709 HP-UX Mission Critical Operating Environment
1. Login as root.
2. Copy ONCplus version B.11.31_LR, B.11.31.01, B.11.31.02, or B.11.31.03 to /tmp/
ONCplus_B.11.31.depot.
Installation Information 11