ONCplus B.11.31.03 Release Notes

Installation Information
This section specifies the requirements for installing ONCplus B.11.31.03. It includes information
on installing ONCplus B.11.31.03 and verifying the ONCplus B.11.31.03 installation.
System Requirements
The following requirements are necessary for installing ONCplus B.11.31.03 :
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 50 MB
Installing ONCplus B.11.31.03
To install ONCplus B.11.31.03 on your system:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, issue the following
command:
swlist | grep ONCplus
The output should be similar to one of the following three lines:
ONCplus B.11.31.02 ONC+ 2.3
ONCplus B.11.31.01 ONC+ 2.3
ONCplus B.11.31.LR ONC+ 2.3
3. After you download the ONCplus_B.11.31.03.depot file, move it to the /tmp directory:
/tmp/ONCplus_B.11.31.03.depot
4. Verify that the file has downloaded correctly using the swlist command as follows:
NOTE: You must specify the full path name of the source depot when you use swlist
and swinstall commands.
swlist -d @ /tmp/ONCplus_B.11.31.03.depot
If ONCplus downloads correctly, the following message appears:
ONCplus B.11.31.03 ONC+ 2.3
5. Back up your system before installing the product.
6. Enter the following command to install the product on a stand-alone system:
swinstall -x autoreboot=true -s \
/tmp/ONCplus_B.11.31.03.depot ONCplus
NOTE: ONCplus contains kernel filesets. Thus swinstalling the product will result in a
system reboot after the installation is complete.
Verifying ONCplus B.11.31.03 Installation
To verify if the ONCplus B.11.31.03 installation is successful, follow these steps:
1. Issue the following command:
swverify ONCplus
If ONCplus B.11.31.03 is successfully installed, the following message displays:
Verification succeeded
12 ONCplus Release Notes