ONCplus B.11.31.02 Release Notes

System Requirements
The following section lists the requirements for installing ONCplus B.11.31.02 :
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 50 MB
Installing ONCplus B.11.31.02
To install ONCplus B.11.31.02 on your system, follow these steps:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, issue the following
command:
swlist | grep ONCplus
An output similar to the following is displayed if you have installed the previous ONCplus
ISU version (B.11.31.01) :
ONCplus B.11.31.01 ONC+2.3
An output similar to the following is displayed if you have installed the initial ONCplus
version shipped with HP-UX 11i v3 :
ONCplus B.11.31_LR ONC+2.3
3. After you have downloaded the ONCplus_B.11.31.02.depot file, move it to the /tmp
directory:
/tmp/ONCplus_B.11.31.02.depot
4. Verify that the file has downloaded correctly using the swlist command as follows:
NOTE: You must specify the full path name of the source depot when you use swlist
and swinstall commands.
swlist -d @ /tmp/ONCplus_B.11.31.02.depot
If ONCplus has downloaded correctly, the following message appears:
ONCplus B.11.31.02 ONC+2.3
5. Back up your system before installing the product.
6. Enter the following command to install the product on a stand-alone system:
swinstall -x autoreboot=true -s \
/tmp/ONCplus_B.11.31.02.depot ONCplus
NOTE: ONCplus contains kernel filesets. Thus swinstalling the product will result in a
system reboot after the installation is complete.
Verifying ONCplus B.11.31.02 Installation
To verify if the ONCplus B.11.31.02 installation was successful, follow these steps:
1. Issue the following command:
swverify ONCplus
If ONCplus B.11.31.02 is successfully installed, the following message is displayed:
Verification succeeded
8 ONCplus Release Notes